Iron ore is an ore that contains iron that can be used economically. It is rich in species, but magnetite, hematite, and siderite are common. As for the crushing of iron ore, currently used in China is a combination crushing mode of jaw crusher and hammer crusher. The process is roughly to use the jaw crusher to coarsely crush the iron ore at first, and then use the hammer crusher. After the crusher is crushed, the dry separation operation is performed directly. In fact, such a mode of operation has caused a huge waste of resources, which has greatly increased the production costs of the company. At present, the crushing production line for iron ore is set up using the COARSE JAW CRUSHER, FINE JAW CRUSHER, AND HAMMER CRUSHER and COARSE JAW CRUSHER, CONE CRUSHER, AND HAMMER CRUSHER. Doing like above not only to solve the problems of the traditional iron in the crushing, but also save the crushing costs and resources, improve the utilization efficiency of iron ore, which greatly increased the company's production capacity and profitability.
JAW CRUSHER
HAMMER CRUSHER
The lowest operating cost crushing mode is using two jaw crushers and hammer crusher to crush iron ore .After crushed by coarse jaw crusher, the large stones become smaller ones reaches 80mm or less, then crushed to 30mm-level by fine jaw crusher. After the crushing of the iron ore, the crushing of the crushing stone is achieved with a broken crusher. Grade fine material and fine aggregate can be broken into professionally-made iron ore fine crusher to crush the iron ore into the desired finished material. Since the jaw crusher is the crusher type with the lowest power consumption and wear, the loss of equipment is reduced. The cone crusher plays an important role in the process of COARSE JAW CRUSHER, CONE CRUSHER, AND HAMMER CRUSHER. Cone crusher is a crusher designed for hard and high-hard materials in China. Due to the reasonable material selection and structural design, it will not have much damage in the high-hard materials such as broken iron ore, so it has a long service life. , But the process is relatively costly compared to the two-stage smashing and the crushing process of a fine crusher, but the shape of the granules is better and the yield is higher.
